lister a dimentions ...

looking to find out the width ( length of crank ) and the diameter of a flywheel . im looking to buy one but not sure if will fit down the back ... might have to have it turned around on trolley so flywheels sitting across the frame .

regards , matt

MATT..
i thought you had sorted this already???
i will look in the book tomorrow mate and see if its in there for you..
regards,mike.

i thought ut would fit but might be a bit of a tight squeeze , so i thought if turned engine 90 deg's would be thinner ...

matt86_wd2 wrote:i thought it would fit but might be a bit of a tight squeeze , so i thought if turned engine 90 deg's would be thinner ...

MATT..what you need is a ramp at the front door,in one end and out the other door..like i said before,get 2 bits of old carpet and run it on one then move the other bit and run it on that bit and so on till it out of the house,that way you wont get any oil or mud on the carpet in the house,and the wife will be well happy...
regards,mike.

yeah i could do that but the alleyway is 36" wide so wider than a normal door

matt86_wd2 wrote:yeah i could do that but the alleyway is 36" wide so wider than a normal door

MATT..will check the book of words tomorrow for you...
regards,mike.

MATT..
I've been out in the shed and got the LISTER A/B book,the info on dimensions work out at about about 32" from end to end...
will take a picture and email it to you so you can See for yourself..
its a bit strange the way they work it,if its a wide flywheel one then it going to be 1 1/2" wider..
hope this helps you.
regards,mike.

MATT..
here's the photos from the book,you can work out the measurements for yourself..hope it helps you....
i know for a Lister l in a trailer,mite be something for you????




regards,mike...

that helps alot mate 1 question is cts inches ... ??

matt86_wd2 wrote:that helps a lot mate 1 question is cm or inches ... ??

oh bugger,i didn't get that in the picture,well i will have a look in the morning mate..
will post it for you once i know the answer,as its dark out side and raining mate..
regards,mike.

Matt just checked and cts are not inchs but this might help

http://www.onlineconversion.com/length_common.htm

Stu.

cant seem to find cts stu

I don't understand it either but you can now convert the cm to inchs.

Stu.

sorry i didn't get back to you on this subject,but have a good excuse..
glad STU could help you..
regards,mike.

thats ok mike these things happen mate .

and it should fit through the door fine but going to be a heavy lump to lift up and over the front and rear door frame